T Rex Skull Upper Jaw

So when I printed the top skull, the mini asked me to resize again, and I said yes.

Screen Shot 2015-06-28 at 11.53.48 PM

I’m sure they know I’m resizing for a Mini, right?

Screen Shot 2015-06-28 at 11.56.18 PM

 

The mini resized the jaw to fit on the printbed, but the jaw was parallel to theĀ printbed. The skull was resized to fit the printbed as well, but theĀ skull was facing upward. There were two scales going on. Had I paid attention, I would have had to set the scale for the skull to match the jaw. Mr. T Rex has a severe overbite.

 

**note: top picture was taken with webcam in GoogleHangouts.

T-Rex Skull Lower Jaw

Printed the lower jaw of the T Rex Skull I found on Thingiverse here. I printed this on the Replicator Mini and it asked if I wanted to resize. I didn’t think anything of it, and clicked yes so that it would print…

IMG_7069

And it printed fine. See next day for why you should not do so without thinking it through.

IMG_7072